2. Loosen the lug nuts by turning them
counterclockwise one turn each,
but do not remove any lug nuts
until the tire has been raised off the
ground.
NOTE
If your Mazda is equipped with the
optional antitheft wheel lug nuts, a
special key must be used to unlock
the locking lug nut for each wheel.
For details, refer to “Locking Lug
Nuts” below.
3. Place the jack on the ground.
4. Turn the jack screw in the direction
shown in the figure and adjust the
jack head so that it is close to the
jack-up position.
5. Place the jack under the jack-up
position closest to the tire being
changed with the jack head
squarely under the jack-up point.
6. Continue raising the jack head
gradually by rotating the screw with
your hand until the jack head is
inserted into the jack-up position.
WARNING
Use only the front and rear jacking
positions recommended in this
manual.
Attempting to jack the vehicle in
positions other than those
recommended in this manual is
dangerous. The vehicle could slip
off the jack and seriously injure or
even kill someone. Use only the
front and rear jacking positions
recommended in this manual.
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-25
Mazda3_8LX5-EA23E_Edition2_new 2023-4-17 20:22:43
To Next Page
Loading...
