Mazda 3 2004 - Page 508

the winter season―and before
traveling where temperatures may drop
below freezing.
Inspect the condition and connections
of all cooling system and heater hoses.
Replace any that are swollen or
deteriorated.
(SKYACTIV G 2.0, SKYACTIVG 2.5
and e-SKYACTIV G)
The coolant should be at full in the
radiator and between the FULL and
LOW marks on the coolant reservoir
when the engine is cool.
(SKYACTIVG 2.5T)
The coolant should be at full in the
radiator and between the FULL and
LOW marks on the coolant reservoir
when the engine is cool.
FULL
LOW
If it is at or near the LOW position, add
enough coolant to the coolant
reservoir to provide freezing and
corrosion protection and to bring the
level to FULL.
Securely tighten the coolant reservoir
tank cap after adding coolant.
CAUTION
Radiator coolant will damage paint.
Rinse it off quickly if spilled.
If the “FL22” mark is shown on or
near the cooling system cap, use of
FL22 is recommended when
replacing engine coolant. Using
engine coolant other than FL22 may
cause serious damage to the engine
and cooling system.
If the coolant reservoir is empty or new
coolant is required frequently, consult
an Authorized Mazda Dealer.
Inspection and Servicing/Cleaning
Engine Compartment Inspection
9-19
Mazda3_8LX5-EA23E_Edition2_new 2023-4-17 20:22:43