Form No. 8P95-EA-00G
In Case of Emergency
6-6
2. Turn off the engine of the vehicle
with the booster battery and all
unnecessary electrical loads in both
vehicles.
3. Connect the jumper cables in the
exact sequence as in the illustration.
(1) Connect one end of a cable to
the positive terminal on the
discharged battery
①.
(2) Attach the other end to the
positive terminal on the booster
battery
②.
(3) Connect one end of the other
cable to the negative terminal
of the booster battery
③.
(4) Connect the other end to a solid,
stationary, exposed metallic
point (for example, the engine
hanger) away from the
discharged battery
④.
4. Start the engine of the booster
vehicle and run it a few minutes.
Then start the engine of the other
vehicle.
5. When finished, carefully
disconnect the cables in the reverse
order described in Step 3.
WARNING
!
Connecting to Negative Terminal:
Connecting the end of the second
cable to the negative (–) terminal
of the discharged battery is
dangerous. A spark could cause
the gas around the battery to
explode and injure someone.
Connect the cable to a point away
from the battery.
To Next Page
Loading...
