Form No. 8P95-EA-00G
In Case of Emergency
6-9
J94A5003 (J18T5005)
Normal Blown
4. Inspect it and replace if it’s blown.
NOTE
The check engine light comes on
when a ROOM fuse blows or
when a ROOM fuse is removed.
When installing a ROOM fuse,
turn the ignition switch off and
wait 60 seconds before installing
the fuse. If the check engine light
comes on and doesn’t go off, there
is a problem other than the fuse
system. Consult your Authorized
Mazda Dealer.
5. Push in a new fuse of the same
rating, and make sure it fits tightly.
If it doesn’t, have an Authorized
Mazda Dealer install it.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the RADIO circuit.
CAUTION
!
Always replace a fuse with one of
the same rating. Otherwise you
may damage the electric system.
To Next Page
Loading...
