Form No. 8P95-EA-00G
In Case of Emergency
6-23
Q076-23CE
CAUTION
!
(Center Cap)
There is a valve-stem mark inside
the center cap. When installing the
center cap, align this mark with the
tire’s valve stem.
(Wheel Cover)
Align the notch on the wheel cover
with the valve stem when
installing it.
Damage could occur during
installation if the center cap or
wheel cover is not properly
aligned.
076-10A1E
J94A5018
Lug wrench
8. Loosen the lug nuts by turning
them counterclockwise one turn
each, but don’t remove any until
the tire has been raised off the
ground.
076-11EE
Jacking position
J94A5019
9. Place the jack under the jacking
position closest to the tire being
changed.
To Next Page
Loading...
