Form No. 8P95-EA-00G
Maintenance
8-37
J94A7023
(J18Y7037)
Pull out
Tabs
Metal support
3. Hold the end of the rubber and pull
until the tabs are free of the metal
support.
J94A7024_a
(J18Y7038)
Stiffeners
4. Remove the metal stiffeners from
the blade rubber and install them in
new blades.
CAUTION
!
• Don’t bend the stiffeners. You
need to use them again.
• If the metal stiffeners are
switched, the blade’s wiping
efficiency could be reduced.
So don’t use the driver’s side
metal stiffeners on the
passenger’s side, or vice versa.
• Be sure to reinstall the metal
stiffeners in the new blade
rubber so that the curve is the
same as it was in the old blade
rubber.
To Next Page
Loading...
