Form No. 8P95-EA-00G
94S004–002
For rear
center seat
For rear
right seat
Cover
Open
Essential Safety Equipment
2-31
J76TCS06
lap/shoulder belt. See the
instructions on the child-restraint
system for belt routing instructions.
2. To get the retractor into the
automatic locking mode, pull the
shoulder belt portion of the seat
belt until the entire length of the
belt is out of the retractor. Position
the belt correctly, push the
child-restraint system firmly into
the vehicle seat and be sure the belt
retracts as snugly as possible.
Clicking from the retractor will be
heard during retraction if the
system is in the automatic locking
mode. If the belt does not lock the
seat down tight, repeat this step.
3. Inspect this function before each
use of the child-restraint system.
You should not be able to pull the
shoulder belt out of the retractor
while the system is in the automatic
locking mode. When you remove
the child-restraint system, be sure
the belt fully retracts to return the
system to emergency locking mode
before occupants use the seat belts.
4. If your child-restraint system
requires the use of a tether strap,
hook the tether strap by following
the manufacturer’s instructions.
To Next Page
Loading...
