50
4.6 ADJUSTMENT
The only adjustment available on the Front Panel Assembly is the LCD contrast that can be adjusted in
accordance with user’s needs through the contrast knob.
4.7 INSTALLING THE 2070LX
Normally the controller has the 2070LX assembly, but this section contains information of installation of
the 2070LX in case it is not.
1. Turn off the controller using the power switch located in the front plate of 2070-4A Module.
2. Install on the front of the controller and attach to the chassis’ hinge through the two thumbscrews
on the right side and secure it through the latch slide on the left side.
3. Tighten the thumbscrews until the module is secure.
4. Insert the 40-position ribbon plug connector from the Serial motherboard into the P3 Connector.
5. Make sure the 2070LX is correctly opened, closed and secured.
These steps complete the 2070LX installation in the Controller.
To Next Page
Loading...
Need help?
General
