56
Power Supply requirements
These are the electrical specifications of Power Supply Module.
Meets the table tolerances values for voltage range of 95 to
135 VAC, minimum and maximum loads called out in the
table and including ripple noise.
Less than 0.2 % rms, 1% peak to peak or 50 mV
No greater than 5 %, all outputs
130% Vout for all outputs
Output voltage returns to within 1% in less than 500 s on a
50 % Load Change. Peak transient not to exceed 5%
30 watts minimum for 550mS after ACFAIL goes LOW. The
supply is capable of holding up the Unit for two 500ms Power
Loss periods occurring in a 1.5 second period.
+5 VDC compensates 250 mV total line drop.
Open sense load protection provided.
To Next Page
Loading...
Need help?
General
