McCrometer WATER SPECIALTIES FlowCom FC101 - Page 31

30119-50 Rev. 2.2 | 23JUL2020
Page 29
PROGRAMMING
NOTE:
1. Entering the correct pulses per revolution is very important. Contact the factory regarding the pulses per
revolution if unknown.
1. Entering the correct pulses per revolution is very important. Contact the factory regarding the pulses
per revolution if unknown.
Change Digit.
Digit blinks until selected.
Show "-Go to" on Totalizer line.
"L2" Blinks on Rate line.
Cycle back to start of
menu.
Go to menu or run.
From Aux.
Input
Menu
Low-Flow
Cuto
cuto
Show "cuto" on Totalizer line.
Blink “0” on Rate line.
Change Digit.
Digit blinks until selected.
Move Cursor Left to next
digit position.
Display
P
P
Blink off, Save
P
P
Blink off, Save
P
P
Display
Display
9
8
7
6
5
4
3
2
1
0
Default is "0". UP
arrow cycles
through each digit.
LEFT arrow
moves to next
digit location, from
right to left.
PLS-Pr
Pulses per
revolution
Show "PLS-Pr" on Show "PLS-Pr" on
Show "PLS-Pr" on "2" on Rate line.
24
12
10
8
4
2
1
Default is "2".
Selection species
number of pulses
produced by the
sensor for each
propeller
revolution.
Change selection. Selection
blinks until selected.
run
L2
L1
Select next
menu or
run mode.
Next
-Go To
Second Menu Level
15 cuto
16 PLS-Pr
17 -Go to