800-627-8569 17 Reel Disk from McFarlane Mfg.
WARNING
Unexpected Separation Hazard
If the safety chains do not have a current
certifi cation tag, do not use the unit until
properly certifi ed chains are installed. Substandard
safety chains could allow the unit to separate from
the tow vehicle resulting in equipment damage and
personal injury.
5. Attach the safety chain from the unit to the tow vehicle.
The safety chain should be long enough for tight
turns. Don’t allow the chain to drag on the pavement
because it will wear the chain links causing an unsafe
condition.
6. Make sure the electrical wiring harness for the running
lights and taillights is properly connected and not
touching the road, but loose enough to make turns
without disconnecting or damaging the wires.
7. Have an observer confi rm all running lights, brake
lights, turn signals, and hazard lights are working on
both the tow vehicle and the unit.
8. Verify the brakes on the tow vehicle are operating
correctly.
9. Make sure transport locks are securely in place
around the cylinder rods.
10. Make sure the jack stand is raised and locked in the
storage position.
11. Make sure the wing lock pins are in place.
12. Check mirrors of the tow vehicle to make sure you
have good visibility.
13. Check routes and restrictions on bridges and tunnels.
To Next Page
Loading...
