Reel Disk from McFarlane Mfg. 32 800-627-8569
Maintenance
Safety
WARNING
To prevent serious injury or death:
STOP
0
Rolling Over /
Crush Hazard
To prevent serious
injury or death, before servicing, adjusting, repairing,
or performing other work on the unit, always make
sure the tractor or towing vehicle engine is stopped,
the ignition key is removed, the unit is lowered to the
ground, all controls are placed in neutral, the parking
brake is set, and all hydraulic fl uid pressure is
relieved (zero pressure).
Rolling Over Hazard
Block the wheels before performing
maintenance or repairs.
Use Properly Rated Tools
Use suffi cient tools, jacks, and hoists
that have the capacity for the job.
Crush Hazard
Use support blocks or safety stands
rated to support the load when
changing tires or performing maintenance.
High-Pressure Fluids
Never use your hands to locate
a hydraulic leak. Use a piece of
cardboard or wood. Wear proper hand and eye
protection when searching for a high-pressure
hydraulic leak.
Hydraulic fl uid escaping under pressure can
penetrate the skin. Openings in the skin and minor
cuts are susceptible to infection from hydraulic fl uid.
If injured by a concentrated high-pressure stream of
hydraulic fl uid, seek medical attention immediately.
Without immediate medical treatment, serious
infection or toxic reaction can develop if hydraulic
fl uid penetrates the surface of the skin.
Entanglement Hazard
Keep hands, feet, clothing, jewelry, and long
hair away from any moving parts to prevent
them from getting caught.
SAFETY
INSTRUCTIONS
Follow all operating, maintenance, and safety
instructions found in this manual.
Understand the service procedure before
performing the work. Keep area clean and dry.
N
I
NG
AR
Replace all worn or damaged safety and
instruction decals.
Keep all parts in good condition and properly
installed. Fix damage immediately. Replace
worn or broken parts.
Do not leave tools lying on the unit.
Do not modify machine or safety
devices. Do not weld on the unit.
Unauthorized modifi cations may impair
its function and safety.
If equipment has been altered in any
way from the original design, the
manufacturer does not accept any
liability for injury or warranty.
OEM
Never replace hex bolts with less than Grade 5
bolts unless otherwise specifi ed. In locations
where grade 8 bolts are used, grade 8
replacements are required.
OEM
Where replacement parts are necessary for
periodic maintenance and servicing, genuine
factory replacement parts must be used to
restore the unit to original specifi cations. The
manufacturer will not claim responsibility for
damages as a result of the use of unapproved parts.
To Next Page
Loading...
