800-627-8569 35 Reel Disk from McFarlane Mfg.
c. Retighten all of the bolts holding the blades onto
the spiral reel.
2. Prior to each use, visually check for loose or missing
bolts and replace lost or worn parts.
3. Grease all hinge pins every 15 hours of service.
4. Grease both ends of all turnbuckles every 24 hours of
service.
5. Clean, repack, and adjust the wheel bearings
annually. Use only wheel bearing grease when
repacking these units. Check for excessive end play.
To adjust wheel bearing, remove dust cap and cotter
pin. Lift tire and slowly rotate while tightening the
spindle nut. Tighten only until a slight drag is felt on
the rotating wheel. Re-install cotter pin and dust cap.
6. Refer to the parts illustrations and listings for service
and repair parts.
7. Spiral reel bearings should be lubricated annually.
Note: Clean grease fi ttings and replace those that are
broken or missing.
To Next Page
Loading...
