McHale 991 - Electronic Control Box Functions and Buttons

McHale 991 High Speed Round Bale Wrapper
37
7.2 Electronic control box functions
No. Function
1
Display Up
2
Press and hold ESC to reset the current wrap count in manual mode
3
Enter
4
Display Down
5
Emergency Stop
6
Display Screen
7
Table lower
If Continuous is set to On then press button 7 during wrapping to prevent
automatic tipping of individual bales. (Useful on hills)
8
Table tip (In Automatic Mode, it starts the tipping part of the cycle)
9
Cut & hold close
10
Cut & hold open
11
Table reverse (slow)
12
Table forward (slow/fast)
Press the button for slow speed, release & quickly press it again for fast
Resume: Restarts the wrapping or any other interruption.
One press of this button during wrapping will engage the slow speed.
Pressing again will resume full rotation speed.
13
Automatic/Manual mode
14
Automatic cycle start. If ‘Auto Load’ is set to On or Semi then press and hold
AUTOSTART to re-wrap. (Skips the loading sequence)
15
Bale lift arm down
16
Bale lift arm up
17
Hold for 3 seconds to select “1 roll of film” mode
18
Hold for 3 seconds to select “2 rolls of film” mode