McHale F5500 - Page 43

McHale F5500 Baler
43
2. Lift the net roll brake bar upwards
and roll the roll of net into the net box.
3. With the roll of net positioned in the
net box, lower the brake bar down
onto the roll of net.
Adjust the net roll stops at either end
to secure the roll of net centrally in
the net box.
4. Before threading the net, ensure that
the net knife is in the re-set position.
The net knife can be re-set by pulling
upwards on the knife frame bar until
the hook sits on the net adjustment
handle. (F)
5. Press the roller tension release lever
(A) downwards until it locks in
position, which results in the two
steel rollers being spread apart from
the black net-feed rubber roller.
6. Thread the net as shown. The net
should be routed underneath the first
steel roller and over the black rubber
drive roller.
When the net is threaded, pull
upwards to release the roller tension
lever (A) which will compress the
three net rollers together.
The roll of net is now threaded and
ready for baling.
F
A
A