McHale F5500 Baler
77
7.4 Warning messages
Net knife is tripped
This warning means that the net knife is already in the
tripped position and net cannot be fed. The net knife needs
to be manually reset and netting can be re-started by
pushing Button 2.
Check net
This warning will usually be displayed if the roll of net
breaks or runs out. If the net knife is not seen to trip after
20 seconds of netting start then the warning is activated.
Low voltage
This warning means that the power supply voltage is below
10.5 V.
Check the tractor battery and all power lead connections.
A fused power cable directly to the battery is the preferred
option.
Drop floor too low
This warning means that the drop floor is not in the fully
raised position. Press Button 4 and operate the pick-up
spool to raise the floor.
Check for any loose crop build up preventing the floor from
raising fully.
To Next Page
Loading...
