25
• When data is 100% analysed, select “Next”
• The next two screens will report on your
speaker sizes (either large or small). For
more information about Speaker Size see “”
on page 19. Select “Next” to leave these
screens. (The second screen may not have
speaker information depending on the number
of speakers in your system)
• Next two pages show any adjustments to
Speaker Level Trims. Values used to equalize
speaker settings will be listed
• Next two pages concerns any adjustments
to delay differentials for speakers. Audyssey
will calculate needed timing corrections. The
screen will display relative Speaker Distances
in meters. Relative Speaker Distances are
used to determine timing corrections.
• Select “Save” on the next screen (Figure 27)
to keep the new Audyssey setup. Selecting
“Abort” will discard the settings. Select
“repeat” to discard and re-run Audyssey setup
Note: Do not change the speaker connections or
subwoofer volume after Audyssey
®
Setup. If these
are changed, run Audyssey
®
Setup again in order to
congure the optimum equalizer settings.
Error Messages
An error message is displayed if Audyssey Setup
could not be completed due to speaker placement,
the measurement environment, etc. If an error
message is displayed, check the relevant items and
perform the necessary measures. Be sure to turn off
the power before checking speaker connections.
See “Figure 28– Audyssey error table” on page
26.
Figure 26– Audyssey measurements complete
Figure 27– Saving Audyssey calibration
To Next Page
Loading...
