McIntosh MX100

7
Making the Cuts
Here are the dimensions for the cutouts needed for
custom installation. A ventilation opening is essential
for any installation with the four feet removed.
Figure 02– Custom cutout
dimensions
Cutout Opening for Custom Mounting
MX100 Front Panel
Custom Cabinet Cutout
Support
Shelf
Chassis
Spacers
MX100 Side View
in Custom Cabinet
MX100 Bottom View
in Custom Cabinet
Cabinet
Front
Panel
Opening
for Ventilation
Note: Center the cutout Horizontally
on the unit. For purposes of
clarity, the above illustration
is not drawn to scale.
Cutout Opening for Ventilation
16-7/8"
42.8cm
3-1/4"
8.2cm
25/32
"
2.0cm
29/32
"
2.4cm
3"
7.6cm
11-19/32"
29.4cm
15"
38.1cm
Cutout Opening
for Ventilation
10- 9/16 "
26.9cm
14- 7/16 "
36.7cm
3"
7.6cm
INPU T
/
M X 10 0 A V P R O CE S S O R
BD
DOLBY ATMOS
VOLU ME
PUSH - SET UP / TRIM PUSH - POW ER
Rack Mounng
To rack mount the MX100, the two included Side
Rack Mount Brackets should be installed. Follow
these instructions for each side:
• Remove the two screws from the front side of
the MX100’s side panel
Figure 03–
Remove two
Screws from
the Chassis
Sidewall
and save
them for
future use if
the Mounting Brackets are removed
Front Panel
Side Panel
Rack Mount screws
• Secure the Side Rack Mounting Bracket to
the MX100 using the larger supplied screws.
Do not re-use the previously removed screws.
Use the smaller supplied screws to secure the
bracket to the Front Panel.
Figure 04–
Side Rack
Mounting
Bracket
Larger
Supplied
Screws
Smaller Supplied
Screws
Front Panel
Side Panel
Installing Rack Mount Bracket