30
Audio Specifications
Unless otherwise noted, the below MX100
Specifications where taken with Audyssey
®
bypassed.
Frequency Response
±0.5dB from 20Hz-20,000Hz
Total Harmonic Distortion
0.005% maximum from 20Hz to 20,000Hz at rated
Output
Signal To Noise Ratio
High Level: 96dB below rated output (A-Weighted)
Rated Output Voltage
5V Balanced Outputs
Output Impedance
330 Ohms
Coaxial/Optical Digital Input Rate and Formats
32kHz to 192kHz, 24-Bit PCM, Multichannel
PCM, Dolby Digital, DTS
HDMI Input Rate and Formats
32kHz to 192kHz, 24-Bit PCM, Dolby Atmos, DTS
Room Correction
Audyssey MultEQ XT32 with Dynamic Volume
and Dynamic EQ
Video Specifications
HDMI (Inputs and Outputs)
Version 2.0, High Dynamic Range (HDR),
Dolby Vision, HDR10, HLG, 18Gbps 4K Ultra
HD@50/60Hz, 4:4:4 Color, Rec. 2020, 3D Video
pass-through
HDCP
Version 2.2
General Specifications
Power Requirements
Field AC Voltage conversion of the MX100 is not
possible. The MX100 is factory configured for one of
the following AC Voltages:
100 Volts, 50/60Hz at 30 watts
110 Volts, 50/60Hz at 30 watts
120 Volts, 50/60Hz at 30 watts
127 Volts, 50/60Hz at 30 watts
220 Volts, 50/60Hz at 30 watts
230 Volts, 50/60Hz at 30 watts
240 Volts, 50/60Hz at 30 watts
Standby, less than 0.5 watt
Note: Refer to the rear panel of the MX100 for the
correct voltage.
Overall Dimensions
Width is 17-1/2 inches (44.5cm)
Width with Side Mount Brackets 19 inches (48.3cm)
Height is 4-15/16 inches (12.5cm) including feet
Depth is 21 inches (53.3cm) including the Front
Panel, Knobs, Rear Panel Connections and USB
Drive
Weight
17 pounds (7.7 kg) net, 39.5 pounds (18 kg) in
shipping carton
Shipping Carton Dimensions
Width is 26-1/2 inches (67.3cm)
Depth is 17 inches (43.2cm)
Height is 24-1/4 inches (61.6cm)
Remote Control
HR085
To Next Page
Loading...
