Video Setup Menu
SETUP: VIDEO > HDMI SETUP > ARC
enabled, will work with the TV Audio input and a
functions to ensure audio and video are perfectly
matched. This allows for more intelligent operation
between components as well as less cable clutter.
SETUP: VIDEO > HDMI SETUP > CEC
to the HDMI standard which allows control signals
from one device to communicate with another device
via an HDMI cable connection. If you change HDMI
control settings, reset power to connected devices.
Notes: 1. To use ARC, CEC must also be set to On.
2. To use CEC and the additional commands of TV
audio switching, power off control and power
saving, CEC must be set to on, so your television and
MX200 can better communicate.
3. To power ON the MX200 via CEC, ensure Network
Control is set to ON.
certainly getting better, but not every component in
the world is speaking precisely the same language.
There may be circumstances where you may have
These features can be enabled or disabled at any time
Video Setup Menu from Browser
and are only accessible through the browser interface
of the setup menu.
TV Audio Switching
TV audio switching, when set to ON, will switch to
TV audio when receiving a command from the TV.
cally switch to TV audio when receiving a command
from the TV.
Power O Control
Power Saving
The video setup menu has the following options:
Setting Input
HDMI Setup Submenu described below
OFF, BOTTOM, TOP
TV Audio Switching* ON, OFF
ALL, VIDEO, OFF
Power Saving* ON, OFF
Note: Some options and settings are only available on the browser
version of the setup menu these are indicated with an *.
SETUP: VIDEO > HDMI SETUP
The Video setup menu has one main submenu for
HDMI settings, the options for it are shown below.
Setting Input
PASSTHRU
ON, OFF
ON, OFF
SETUP: VIDEO > HDMI SETUP > PASS THRU
Pass through (written as HDMI PASSTHRU on the
front display) allows an HDMI input to be assigned
so that when a signal is received by that HDMI input,
received for video and audio playback by a connected
TV or monitor.
Note: CEC should be disabled if you plan to use the pass through
feature to avoid your TV turning on your MX200 and other
unexpected results.
SETUP: VIDEO > ON SCREEN DISP
On screen display, when On, will display the
volume on an attached TV when the volume is
Bottom and Top refer to the position on the TV
where the volume will be displayed. Both Bottom
and Top enable (on) the on screen display feature.
To Next Page
Loading...
