22
Use the Play Button to test channels individually
to hear if their level is suitable. Slowly raise the
master output level until sound can be heard.
• Repeat this step for each speaker.
11. Once each channel is complete, adjust the Master
output to a normal or slightly loud listening level.
Calibration notes:
• A common master volume range is -35dB to -25dB.
• A signal-to-noise ratio error indicates too low of audio to
measure. Master output may need to increase.
• A clipping error indicates too high of an audio level to
measure. Master output may need to decrease.
• If your subwoofer has gain control, this control may need to
be adjusted to assist with the volume calibration of that channel.
Select Arrangement
12.
measurements: Tightly Focused, Focused, and
Wide Imaging.
13. Please choose one that matches closest to your
own listening arrangement. A wider listening
positions with the microphone
Measure
Place the microphone closest to the listening
position shown in arrangement image.
Press “Measure selected position.”
16.
Note: While measuring a 7.2.4 system, the test tone will appear to
come from both subwoofers together. This is normal.
measured.
measurement.
Dirac Live
®
Setup
Please review the Dirac Live User manual setup
and operation before beginning to calibrate your
system. Information regarding the user manual and
other tips may be found at
1.
https://www.dirac.com/live/downloads
2.
layout using either the front panel or the browser
which proper channels to enable to deliver audio
Note: After completing “Amp Assign”, press “Next”, and finally
press “Start.” This refreshes NET connection to DIRAC
within the MX200. Please wait at least 30 seconds to
connect to the MX200 within the Dirac Live app.
3.
lights, etc.).
Select Device (MX200)
Select recording device (microphone). An icon
with a microphone should appear with a graph.
6.
Select “Use from device.”
Volume Calibration
Set the Master output to a low setting to avoid
damage to ears or speakers.
9.
19.
Note: Please take the time to SAVE your current project at this
point, as it will allow you to open this measurement and edit
your filter in the future without having to remeasure your
arrangement again.
Filter Design
Dirac Live will automatically generate a
performance and tune their response to meet the
suggested curve. These curves can be adjusted to
your preferences.
21. To manually adjust the generated curve, follow
the Dirac Live User Manual on Filter Design.
Filter Export
22.
23. Dirac will give the opportunity to name and
The Dirac Live process is now complete, and
Dirac may be enabled or disabled with available
Future Filter Edits:
Amp Assignment must be set to the same settings
as when the project was measured with to be able
To Next Page
Loading...
