www.marketdirect.com.au Ph: 1300 494 494
12
First, open the ue dust cover
shown.
Second, remove the Truma
factory cover by placing thumbs
in the middle of the cover and
pulling the top towards you with
your ngers.
The ue should look like this
when ready to use
• For gas cylinders stored in a dedicated LP Gas Locker ensure the locker is kept closed at all times unless
changing or operating the cylinders.
• Close cylinder valves when appliances are not in use or while refuelling is in progress.
• Ensure cylinder valves are closed to prevent the unintended release of gas from a cylinder.
Gas Appliance Safety
• Gas appliances are certied and have a ame safeguard feature to stop gas ow in the event of the ame going
out. Never interfere with this function or replace appliances with a non-certied type.
• Slide-out kitchens with cookers should only be operated with an annex fully erected. Failing to do so may affect
the safety and operation of the gas appliance.
• Slide-out kitchens with cookers must only be used with a exible connecting hose that is disconnected from the
gas bayonet tting when in its stored position. Under no circumstances permanently connect this appliance.
• Only approved and suitable gas appliances with ame safeguard systems shall be connected to the gas bayonet
(if tted).
Removing the Hot Water System Flue Cover
To use your inbuilt Truma hot water system, the external ue covers must be removed prior to starting the unit.
Removing Door Vent Cover
The door vent must be uncovered at any time the camper is occupied.
To Next Page
Loading...
