Mecmesin MultiTest 1-dV - License Keys

10  Mecmesin MultiTest-dV Operating Manual
To switch from dV(u) to dV mode open the device information panel within VectorPro
and click the switch located at the bottom of the panel (Shown below).
3.4. License Keys
A VectorPro Lite license key is required to run dV tests within VectorPro, this key is not
required when testing in dV(u) mode but you do require a dV(u) key to switch the stand
from dV mode to dV(u) mode.

Click the test stand switch located in the information panel to swa
p between
dV
and dV(u) mode