18 Mecmesin MultiTest-dV Operating Manual
4.9. ELS - Enhanced Load Sensor
Enhanced load sensors or ELS for short, are smart devices used to capture load readings
for MultiTest-dV test stands operating in dV(u) mode.
All calibration information is held in the individual load cell meaning they can be
swapped from system to system and the calibration will follow.
These load cells are available in a range of sizes and designs to best suit your
requirements. See the MultiTest-dV Specification of this document for details relating
to capture rate and accuracy.
A selection of enhanced load sensors (Not all ELS devices shown are compatible with
MultiTest-dV test stands)
To Next Page
Loading...
