Mecmesin MultiTest 1-dV - 13 Test Stand Firmware; Software Compatibility Table

50  Mecmesin MultiTest-dV Operating Manual
Please note the stand must a MultiTest
-
dV Mark 2 with a serial number after 17
-
1XXX
-
11 to operate in dV(u) mode
13. Test Stand Firmware/ Software Compatibility Table
The tables below can be used to identify what versions of VectorPro can be used with
your test stands firmware.
 To identify the firmware navigate to the information panel within the test stand’s
settings menu.
 The software version can be identified by clicking the VectorPro icon located in
the centre of the top header bar or visually on the main login window.