Mecmesin MultiTest-x Series - Page 58

Appendix 6: MultiTest-x Menu Options Page 6
Press
[1/Menu]
Press
[1/Menu]
[1], [3], [2], [2] Set Limits
Press
[2]
[1], [3], [2], <3> Auto Xmit Res-OFF
Press
[2]
1) Select Analysis
2) Set Limits
3) Auto Xmit Res-OFF
4) Calculate Results
1) Procedure 1
2) Print Menu
3) Setup Menu
4) Utilities Menu
Press
[3]
1) Acquisition Menu
2) Analysis Menu
3) Control Menu
Press
[2]
1) Select Analysis
2) Set Limits
3) Auto Xmit Res-OFF
4) Calculate Results
Press
<3>
to toggle between
ON and OFF
If ON is selected results will
automatically be uploaded to
a PC or datalogger via the
RS232 port
This can only
be selected if a
calculation has
been setup in
Select Analysis
Press [Start/ENT] x2 to
disable the set limits facility
or
type in a value and press
[Start/ENT]
Pk Ld <>Disp
Targ( N): 0
Limits=0 to Disable
Screens displayed
will depend on what
Limit Type has been
set (See [1],[4],<2>)
Pk Ld <>Disp
Targ( N): 0
Tol(%):
Limits=0 to Disable
Type in a value and press [Start/ENT]
to store and display the set limits
screen for the next calculation. Once
the limits of the final calculation is
specified press [Start/ENT]
1) Procedure 1
2) Print Menu
3) Setup Menu
4) Utilities Menu
Press
[3]
1) Acquisition Menu
2) Analysis Menu
3) Control Menu