Song Recording
Press [RECORD] button to enter the user song selection
mode. The “REC” icon, “UserSong” and sequence number
will be displayed on the LCD.
Use data dial, [+/YES] or [-/NO] button to select the user song
you want to record.
Press [RECORD] button again to enter the record mode. Now
four beats and “MELODY 1” (or other tracks) on LCD is
flashing, indicates waiting for recording.
Parameters such as voice, style and tempo can be revised.
When recording a new song, the keyboard will automatically
select “melody 1” as the recorded track. Press other track
buttons to make your own selection.
When recording an existing song, the keyboard will
automatically select the empty track next to the occupied
track. For example, if “Melody 1” is occupied, “Melody 2” will
be selected as the recorded track.
When all 3 tracks have been recorded and a specific track
needs to be revised. Press the button of the desired track and
start recording. The original data will be replaced.
Press [START/STOP] button or play the keyboard to start
recording.
With the easy-to-use song recording features, you can record your own keyboard performances as a User song. 5
user songs can be recorded with 3 tracks (1 ACCOMP track, 2 MELODY tracks) each.
Starting Recording
1.
2.
3.
Note:
2 melody tracks can’t be recorded at the same time. However,
you are allowed to record 1 melody track and 1 accomp track
simultaneously. Style can only be recorded in “Accomp” track.
24
Choosing Tracks
There are 3 status of the track cursor on the left side of the
LCD: Lighten Flashing and Darken.
When the cursor is flashing, it indicates the flashing track is the
track to be recorded.
When the cursor is lightened, it indicates there has recorded
data in this track. The data in this track will be played while
recording for another track.
When the cursor is darkened, it indicates there’s no data in this
track or there’s data in this track but it’s forbid to play while
recording another track.
You can press “Accomp” (or “Melody 1” to “Melody 2”) to select
the desired track. The corresponding track will be switched from
the above three states by pressing the track button repeatedly.
To Next Page
Loading...
Need help?
General
