Mark V ProVis Injection System
TOC - 4
16 - System Disassembly and Reassembly Procedures
Introduction 16 - 1
Replacement Parts 16 - 2
Replacement Circuitry 16 - 4
How to Order Parts 16 - 6
Required Tools 16 - 7
Control Unit
Electronics Console Access 16 - 8
PC Cards 16 - 9
Control Panel
Removal and Replacement 16 - 10
Display Card 16 - 11
Controller Card 16 - 12
Injector Head
Covers 16 - 13
Syringe Heat Maintainer 16 - 14
Plunger Position Pot 16 - 16
Mechanical Stop Pot 16 - 19
Plunger Motor Drive Belt 16 - 21
Plunger Drive Motor 16 - 23
Mechanical Stop Motor 16 - 25
Head Control Panel 16 - 27
Mechanical Stop Limit Switch 16 - 28
Injector Head Cable 16 - 29
Oil Seal 16 - 30
Pivot Knuckle Adjustment 16 - 31
Power Switch 16 - 32
Line Voltage Conversion 16 - 33
Line Frequency Conversion 16 - 35
Line Frequency Checkout 16 - 36
To Next Page
Loading...
