Megmeet MV300 Series - Page 106

106
1: Enable option reset
P40.23
Profibus-DP
PPO type
selection
Profibus-DP
PPO type
selection
1~5: PPO1~PPO5 1 1 × √ ○
P40.24
Communica
tion baud
rate display
or selection
Communicati
on baud rate
display or
selection
Profibus-DP: Display the current
communication baud rate
0: 9.6 kbps; 1: 19.2 kbps;
2: 45.45 kbps; 3: 93.75 kbps;
4: 187.5 kbps; 5: 500 kbps;
6: 1.5 Mbps; 7: 3 Mbps;
8: 6 Mbps; 9: 12 Mbps
Other options: Reserved
1 0 × √ ○
P40.25
Option fault
display
Option fault
display
0: Option is normal
1: Option wire-break or other
faults
1 0 × √ *
P40.26
~
P40.29
Reserved
P40.30
~
P40.39
Bus output
data
mapping
Bus output
data
mapping
0~9999
Please refer to the Option Manual
for details
1 0
× √ ○
P40.40
~
P40.49
Bus input
data
mapping
Bus input
data
mapping
0~9999
Please refer to the Option Manual
for details
1 0
× √ ○
Group P97: Protection and fault parameters
P97.00
Fault
protection
and alarm
property
setting 1
Fault
protection
and alarm
property
setting 1
Unit place of LED: Action upon
communication fault
0: Activate protection and coast to
stop
1: Alarm and keep running
2: Alarm and stop in the stop
mode (only in serial port control
mode)
3: Alarm and stop in the stop
mode (in all control modes)
Tens place of LED: Action upon
contactor abnormality
0: Activate protection and coast to
stop
1: Alarm and keep running
Hundreds place of LED: Action
upon EEPROM abnormality
0: Activate protection and coast to
stop
1: Alarm and keep running
Thousands place of LED: Action
1 0000 × √ ×