117
When it is set as 7, the M key is used to coast to stop the drive. Under any command channel, once this
key is pressed, the drive will coast to stop.
Thousands place: Locking function of the operation panel
It is used to set the locking range of keys on the operation panel.
Table 6-2 Locking range of keys
Hundreds
place
Function Description
0 Lock all the key
Lock all the keys on the operation panel. When the locking function is
enabled, all the keys on the operation panel are disabled.
1
Lock all the keys except the
STOP/RESET key
Lock all the keys except the STOP/RESET key. When the locking function is
enabled, only the STOP/RESET key can be used.
2
Lock all the keys except the
SHIFT key
Lock all the keys except the >> key. When the locking function is enabled,
only the “>>” key can be used.
3
Lock all the keys except the
RUN, STOP/RESET key
Lock all the keys except the Run and STOP keys. When the locking function
is enabled, only the Run and STOP keys can be used.
0: Parameter changing status
If the parameter value of this function code is set as 0, all the parameters can be changed.
1: Clear fault memory information
If the parameter value of this function code is set as 1, the content of the fault record
(P97.15~P97.21) will be cleared.
2: Restore to leave-factory value
If the parameter value of this function code is set as 2, the function codes of the Group P97.15 will be
restored to the leave-factory values based on the drive type, except for the user password (P00.01), the
drive status display parameters (Group P01) and the motor parameters (Group P03) and P12.04.
3: Restore the quick start function group only
If the parameter 3 is saved in this function code, only the parameters related to the quick running of the
drive will be restored.
0: Disabled
1: Uploading parameter
When it is set as 1 and confirmed, the drive will upload all the function code setting values of Group
P00~P98 in the control panel to the EPPROM of the operation panel to store.
2: Downloading parameters
When it is set as 2 and confirmed, the drive will download all the function code setting values of Group
P00~P98 from the operation panel to the internal control panel to store.
3: Downloading parameters (Except the motor parameters)
Parameter copy 0~3 (0)P00.06
Parameter initialization 0~3 (0)P00.05
To Next Page
Loading...