120
BIT0: RUN/STOP
When the drive is in stop state, the value for the BIT0 place is 0, otherwise, it is 1.
BIT1: REV/FWD
When the drive runs forward, the value for the BIT1 place is 0, otherwise, it is 1.
The corresponding bit will be set to 1 when the condition is met for other bits.
Fig. 6-3 State of digital input terminal
Displaying the ON/OFF state of 6 terminals (X1~X6). “0” means that the terminal is in “OFF” state and “1”
means that the terminal is in “ON” state.
Fig. 6-4 State of digital output terminal
The function code P01.19 can display the state of the output terminals (Y1 and Y2) and the relays (RO1).
When the signal is output, the corresponding place of P01.19 will be set as 1. For example, if the signals
are output from the terminal Y1 only, the place of BIT0 will be set as 1, therefore, the value displayed by
P01.19 is 1.
P01.20~P01.21 are used to display the analog input signal before the adjustment.
Note
When the current input is selected for the analog input, the AI input range is 4 to 20mA, and the corresponding
display range is 2 to 10.
AO1 output
0.0~100.0%(0.0%)
P01.23
Reserved
0
P01.22
AI2 input voltage
-10.00~10.00V(0.00V)
P01.21
AI1 input voltage
-10.00~10.00V(0.00V)
P01.20
State of digital output terminal 0~7H (0)P01.19
State of digital input terminal 0~3FH (00)P01.18
To Next Page
Loading...