Megmeet MV300 Series - Page 175

175
Fig. 6-46 Analog and pulse curve selection
P10.05 is used for selecting the analog and pulse curve.
Where the value range of P10.07, P10.09, P10.11, P10.13, P10.15, P10.17, P10.19 and P10.21 is as
follows: Take as the frequency reference, its value range is 0.0~100.0
％
Fmax; 0.0~300.0
％
Te for the
torque and 0.0~100.0
％
Φe for the magnetic flux.
For example, the demand analysis is as follows:
1
） Setting the set frequency with the pulse signal input by the terminal;
Actual value corresponding to the minimum reference of curve 2
0.0~300.0%
(
0.0%
)
P10.21
Minimum reference of curve 1 0.0%~P10.18
(
0.0%
)
P10.20
Actual value corresponds to the inflection point 1 of the curve 1
0.0~300.0%
(
0.0%
)
P10.19
Inflection
p
oint 1 of the curve 1 reference P10.20~P10.16
(
0.0%
)
P10.18
Actual value corresponds to the inflection point 2 of the curve 1
0.0~300.0%
(
100.0%
)
P10.17
Inflection
p
oint 2 of the curve 1 reference P10.18~P10.14
(
100.0%
)
P10.16
Actual value corresponding to the maximum reference of curve 1
0.0~300.0%
(
100.0%
)
P10.15
Maximum reference of cu
r
ve 1 P10.16~100.0%
(
100.0%
)
P10.14
Actual value corresponding to the minimum reference of line 2
0.0~300.0%
(
0.0%
)
P10.13
Minimum reference of line 2 0.0~P10.10
(
0.0%
)
P10.12
Actual value corresponding to the maximum reference of line 2
0.0~300.0%
(
100.0%
)
P10.11
Maximum reference of line 2 P10.12~100.0%
(
100.0%
)
P10.10
Actual value corresponding to the minimum reference of line 1
0.0~300.0%
(
0.0%
)
P10.09
Mini
m
um reference of line 1 0.0%~P10.06
(
0.0%
)
P10.08
Actual value corresponding to the maximum reference of line 1
0.0~300.0%
(
100.0%
)
P10.07
Maximum reference of line 1 P10.08~100.0%
(
100.0%
)
P10.06