MELAG DAC Premium Plus - Initial Power Connection and Startup

3 Setup and installation
12
Connecting the power cable / removing accessory parts
1. Connect the device power plug to the mains socket.
2. Switch on the device at the power switch. The display shows the
WELCOME screen.
PLEASE NOTE
The display automatically switches to thePrograms & Tests menu after five seconds. Then the
steam sterilizer will attempt to pump water; this will trigger a malfunction message if no feed water is
available.
3. As soon as the WELCOME screen has appeared, press the place of
the second symbol from right in the action bar and hold it depressed
until the display shows the the adjacent screen.
4. Open the door by pressing the door symbol .
5. Remove all accessory parts from the device.