MELAG DAC Premium Plus - Device Settings and Adjustments; On-Device Settings Configuration; IP Address Configuration

4 Settings and adjustment
18
4 Settings and adjustment
Settings on the device
Date and time
Check the date and time and set if necessary, see User manual.
Display settings
If required, working in the Settings menu, adjust the brightness, key tone and the touch-sensitivity, see User manual.
Contact data of the service partner
Working in theSettings >Service menu, enter the name and address of the responsible service partner.
Resetting the maintenance counter
Reset the maintenance counter in accordance with the instructions “Resetting the maintenance counter upon initial
commissioning and maintenance” (doc. PW_common).
User administration and logging
Instruct the user in the user administration and possible logging: consult user manual. If you require an admin PIN, enter
this and any further settings in the record of installation and setup.
IP addresses
NOTICE
The setting up in the (practice) network will require in-depth understanding of the network technology.
Handling errors of IP addresses can result in malfunctions and data loss in your user network.
n IP addresses may only be set by the (practice) network system administrator.
The device is equipped as standard with IP addresses which all belong to a common network with the subnet mask
stated in the following table. These pre-set IP addresses listed in may not yet been assigned in the (practice) network.
Works pre-setting of the device IP addresses
Device IP address Remarks
Steam sterilizer 192.168.40.40 Pre-set ex works
computer 192.168.40.140 Pre-set ex works
Log printer 192.168.40.240 Pre-set ex works
Label printer 192.168.40.160 Pre-set ex works
Gateway 192.168.40.244 Not relevant within a network
Subnet mask 255.255.255.0 Possibly to be adopted by customer network
Additional drying and further program modifications
The stages of the steam sterilizer programs (fractionating, heating, sterilizing, pressure release, drying and aeration) and
its parameters (pressure, temperature and time) are conform with the usual requirements placed by a practice
environment. The Additional drying function in the Settings menu provides a standard possibility of influencing
the course of the program run. Further alterations to the program run are possible in each individual case and will still
ensure the effectiveness of the sterilization, but may only be performed by authorized technicians. Please consult your
stockist or MELAG.