Melitta Caffeo Barista T - Positioning the Appliance; Connecting the Appliance; Switching the Appliance on for the Irst Time

First steps
60
ENGLISH
3.3 Positioning the appliance
Observe the following instructions:
 Do not position the appliance in damp rooms.
 Position the appliance on a stable, at and dry surface.
 Do not position the appliance in the vicinity of sinks or the like.
 Do not position the appliance on hot surfaces.
 Position the appliance a sucient distance, approx. 10cm, away from
the wall and other objects. The space above the appliance should be at
least 20cm.
 Route the power cable so that it cannot be damaged by edges or hot
surfaces.
3.4 Connecting the appliance
Observe the following instructions:
 Check that the supply voltage matches the operating voltage specied
in the technical data (see table Technical data on page95).
 Only connect the appliance to a properly installed earthing contact
socket. If in doubt, consult a specialist electrician.
 The socket must be fused with at least a 10 A fuse.
3.5 Switching the appliance on for the rst time
During initial starting up, you can set the language, the time and the water
hardness. The settings can be changed at a later point in time (see chap-
ter 8 Changing basic settings on page80 and chapter 9.8 Setting the
water hardness on page91).
Use the enclosed test strip to determine the water hardness. Observe the
instructions on the test strip packaging and in table Water hardness range
on page95.
Information
We recommend pouring away the rst two cups of coee after initially
starting up.