Care and maintenance
90
ENGLISH
9.7 "Descaling" programme
The descaling programme is used to remove limescale deposits in the inte-
rior of the appliance using coee machine descaling agents.
To avoid damage to the appliance, we recommend carrying out the descal-
ing programme every 3 months or as requested by the appliance.
The descaling programme takes approximately 25 minutes and should not
be interrupted.
CAUTION
Contact with descaling agent may lead to eye and skin irritation.
Observe the processing instructions on the descaling agent packaging.
ATTENTION
Use of unsuitable descaling agents may damage the appliance.
Use Melitta® ANTI CALC Espresso Machines liquid descaling agent exclu-
sively.
ATTENTION
A water lter may be damaged if it is screwed in during the descaling
programme.
Remove the water lter before starting the descaling programme (see
chapter 9.9 Using a water lter on page91).
Place the water lter into a vessel lled with tap water during the desca-
ling programme.
The water lter can be reinserted and reused on completion of the des-
caling programme.
Requirement: The ready symbol appears on the display.
1. Press the "menu/ok" button for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Descaling menu.
3. Use the arrow buttons to select Start and conrm with "menu/ok".
4. Follow the further instructions on the display up to the end of the desca-
ling programme.
» The ready symbol appears on the display.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
