Melitta CAFFEO CI - Filling the Bean Container

13
ENGLISH
• Fill the bean container (see page 13) and press the rotary switch to
conrm.
→ Theprompttollthewatertankwillappearonthegraphicdisplay.
• Fill the water tank and reinsert it into the appliance (see page 14).
→ TherotaryswitchashesandSystem Start appears on the graphic display.
• Place a vessel under the outlet and press on the rotary switch.
→ Theapplianceperformsanautomaticrinseandhotwaterowsoutof
the outlet. The buttons are then illuminated. The appliance is ready for
operation.
4.4 Filling the bean container
Thanks to the 2-chamber „Bean Select“ bean container, you can use two different
typesofcoffeeatthesametime.Forexample,llonechamberwithespresso
beans, and the other with café crème beans. Then you can conveniently switch
between the two types using the tilt lever.
• Fill the bean container (Fig. A, No. 7) with fresh coffee beans. Each
ofthetwochamberscanbelledwithamaximumof135gofcoffee
beans.
• Select the desired bean type by setting the tilt lever to the appropriate
chamber.
Warning!
Hazard for persons allergic to caffeine.
Since a residual quantity of the previously used beans remains above the
grinder, the two types of beans mix when changing to a different bean type.
Consequently,whenswitchingovertodecaffeinatedbeansthersttwocups
may still contain coffee that is not decaffeinated. This means that only the third
cup of coffee prepared after the switchover is free of caffeine.
Caution!
– Fill the bean container with coffee beans only.
– Neverllthebeancontainerwithground,freeze-dried,orcaramelised
coffee beans.
Heft_CI_Export_2_1.indd 13 26.11.2013 14:00:23