Melitta CAFFEO CI - Changing The Water Filter

43
ENGLISH
• Carefully screw the Melitta
®
Claris
®
waterlterintothethreadonthe
base of the water tank using the screw-in aid at the bottom end of the
coffee scoop provided.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
• Press the rotary switch.
•
Place a vessel with an approximate capacity of 0.5 l under the outlet
andpresstherotaryswitchtoconrm.
→ The appliance rinses and then returns to standby mode.
The water hardness is automatically set to Soft.
10.2 Changing the water lter
Changethewaterlterwhenaprompttodosoappearsonthegraphicdisplay.
• Select the Care sub-menu.
• Turn the rotary switch until Filter is highlighted
andpressittoconrmtheselection.
• Turn the rotary switch until Change lter is
highlightedandpressittoconrmtheselection.
• Turn the rotary switch until Start is highlighted
andpressittoconrmtheselection.
• Lift the lid of the water tank (Fig. A, No. 6) and
pull the water tank up and out of the appliance.
•
Unscrewthewaterlterfromthethreadonthebaseofthewaterlter.
• Carefully screw the new Melitta
®
Claris
®
waterlterintothethreadon
the base of the water tank using the screw-in aid at the bottom end of
the coffee scoop provided.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
• Press the rotary switch.
•
Place a vessel with an approximate capacity of 0.5 l under the outlet
andpresstherotaryswitchtoconrm.
→ The appliance rinses and then returns to standby mode.
Care
Filter
Descaling
Exit
Filter
Insert lter
Change lter
Exit
Heft_CI_Export_2_1.indd 43 26.11.2013 14:00:29