37
ENGLISH
9.6 Integrated cleaning programme
The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 10 minutes. You
can check the progress of the programme at any time on the progress bar on the
graphic display.
For optimal cleaning results, we recommend that you clean the brewing unit
beforehand (see page 32).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, when the
symbol for cleaning appears on the graphic display.
– Only use Melitta
®
cleaning tabs for fully automatic coffee makers. These
cleaningtabsarespecicallydesignedfortheMelitta
®
CAFFEO
®
CI
®
. Use
of other cleaning agents may cause damage to the appliance.
Run the integrated cleaning programme as follows:
1 Lift up the lid of the water tank (Fig. A, No. 6) and
pull the water tank up and out of the appliance.
2
Fill the water tank to the max. mark with fresh tap
water and reinsert it.
3
Connect the tube to the outlet and to the drip tray
(Fig. D).
4
Select the Care sub-menu.
5
Turn the rotary switch until Cleaning is highlighted
andpressittoconrmtheselection.
6 Turn the rotary switch until Start is highlighted
and press it to start the programme.
7
Empty the drip tray and the coffee grounds
container and then reinsert them.
Care
Cleaning
Intensive Cleaning
Descaling
Cleaning
Start
Exit
Heft_CI_Export_2_1.indd 37 26.11.2013 14:00:28