87
4.6 Switching on for the rst time
All of the tubes have been drained and aired out at the factory. For this
reason, the rst time the appliance is switched on, the symbol for the milk
shower will be illuminated after the heat-up phase and the appliance
must be vented via the milk shower.
Caution!
The appliance may only be vented without the Melitta
®
Claris
®
water lter and with a full water tank.
– Insert the Melitta
®
Claris
®
water lter into the water tank only
after venting.
– Fill the water tank with fresh tap water to the max. mark before
venting.
• Press the ON/OFF button to switch the appliance on.
→ The standby symbol is ashing. The appliance heats up.
After heating up, the symbol for the milk shower will be illumina-
ted.
• Remove the milk canister and place a larger vessel under the
milk shower.
• Turn the rotary switch for the milk shower (Fig. A, no. 11) clock-
wise to open the milk shower.
→ The symbol for the milk shower is ashing. Water runs into the
vessel under the milk shower.
• When water is no longer running out of the outlet and the symbol
for the milk shower is illuminated, turn the rotary switch for the
milk shower anti-clockwise to close the milk shower.
→ The appliance is ready for operation.
Heft_Lattea_Fernost_2_3.indd 87 12.05.2014 15:15:41
To Next Page
Loading...
