Melitta CAFFEO LATTEA E 955-101 - Integrated Descaling Programme

ENGLISH
109
11.4 Integrated descaling programme
The integrated descaling programme removes limescale in the interior of
the appliance. It requires a total of approximately 25 minutes. The symbol
for descaling 󰘱ashes during the entire process.
Prerequisite: The appliance must be switched o󰘯 (see 89
„Switching on and o󰘯“ ).
Caution!
– Carry out the integrated descaling programme every 3 months
or when the descaling symbol illuminates on the display.
– Only use Melitta
®
ANTI CALC Espresso Machines descaling
agent. These descaling products are exactly designed for the
Melitta
®
CAFFEO
®
LATTEA
®
.
– Never use vinegar or other descaling agents.
Run the integrated descaling programme as follows:
1 Before descaling, remove – if in use – the Melitta
®
Claris
®
water
󰘰lter from the water tank.
2 Remove the milk canister.
3 Simultaneously press both the button for two-cup dispensing
and the ON/OFF button for about 3 seconds.
→ The symbol for descaling is 󰘱ashing.
The symbol for the drip tray is illuminated.
Phase 1
During Phase 1, one bean symbol is shown on the display.
4 Empty the drip tray and co󰘯ee grounds container.
5 Reinsert the drip tray without the co󰘯ee grounds container and
place the co󰘯ee grounds container under the milk shower.
→ The symbol for the water tank illuminates.
Heft_Lattea_Fernost_2_3.indd 109 12.05.2014 15:15:43