Melitta CAFFEO LATTEA E 955-101 - Preparing Milk Froth

94
8 Preparing milk froth
Prerequisite: The appliance must be ready for operation (see
89 „Switching on and o󰘯“ ).
Place a vessel (e.g. a latte macchiato glass) under the milk canister.
• Remove the milk canister and 󰘰ll it with the milk2shower milk
powder.
• Place the milk canister on the magnetic holding point under the
milk shower (Fig. A, no. 13).
• Turn the rotary switch for the milk shower (Fig. A, no. 11) clock-
wise to open the milk shower.
→ The symbol for the milk shower is 󰘱ashing. Approximately 90 ml
of hot water 󰘱ows into the milk canister and generates the milk froth.
The milk froth runs out of the milk canister into the vessel below the
canister. The 󰘱ow of water stops automatically after about 90 ml.
• Turn the rotary switch for the milk shower anti-clockwise to close
the milk shower (this can also be done prematurely if you desire
less milk froth).
• Now start the co󰘯ee dispensing process, e.g. to prepare a latte
macchiato.
Heft_Lattea_Fernost_2_3.indd 94 12.05.2014 15:15:41