Memmert HCP - Ambient Conditions; Scope of Delivery

Construction and Description
16 D39303 02/2024
compliance requirements which are relevant or specified in the company standard. By
taking this approach, and by making our own observations, we are always able to stay
abreast of developments to the best of our knowledge and ability.
In accordance with the REACH regulation and the RoHS guideline, Memmert provides
information on the chemical substances in Memmert appliances online at:
www.memmert.com
3.9.2.1 REACH information of Memmert GmbH + Co. KG acc. to Regulation (EG) No. 1907/2006, Art. 33
Based on current knowledge, we confirm that products or sub-products containing
substances of very high concern (SVHC in the specified components) in the Candidate List
with concentrations higher than 0.1 mass % are installed in the appliances we supply:
Appliance component Substance in the Candidate List SVHC CAS No.
PTC heating elements Lead
■ 7439-92-1
Blue housing protection film Tris(4-nonylphenyl, branched and linear) phosphite
■ 26523-78-4
■ 3050-88-2
■ 31631-13-7
■ 106599-06-8
Seal inserts made of NBR 2,2’-Methylenbis(4-methyl 6-tert-butylphenol)
■ 119-47-1
3.9.2.2 RoHS Information of Memmert GmbH + Co. KG acc. to Directive 2011/65/EU and Delegated Directive 2015/863
We confirm that we comply with the substance restrictions in accordance with 2011/65/
EU for the supplied products, accessories and spare parts. With regard to the substance
lead, we and/or our suppliers make use of the applications exempted from the restriction
for lead stated in appendix III in a credible, trustworthy manner.
3.10 Ambient Conditions
■ The unit must only be used in closed rooms and in the ambient conditions listed below:
Ambient temperature 10°C to 30°C
Air humidity max. 70% non-condensing
Overvoltage category II
Contamination level 2
Installation altitude a.s.l. max. 2000m a.s.l.
Maximum mains voltage fluctuations AC 115V (± 10%)
AC 230V (± 10%)
■ The unit may not be used in Ex zones. The ambient air must not contain explosive dusts,
gases, vapours or gas-air mixtures. The unit is not explosion-proof.
■ Heavy dust production or aggressive vapours in the vicinity of the unit could lead to
sedimentation in the interior and, as a consequence, could result in short circuits or
damage to electrical parts. For this reason, sufficient measures to prevent large
accumulations of dust or aggressive vapours should be taken.
3.11 Scope of Delivery
■ Mains connection cable
■ 1 or 2 stainless steel perforated shelves (load capacity: 15kg each)
■ Water tank with connection hose
■ 2 sponge plugs for silicone entry ports
■ USB storage medium with software and AtmoCONTROL manual