Memmert HCP - Manual Mode

Operation and Control
28 D39303 02/2024
Programme Mode
The appliance automatically runs programme sequences which have been defined using
AtmoCONTROL software at a computer / laptop and then transferred to the appliance from
a USB stick or via Ethernet.
■ See }6.5.3Programme Mode
Remote control mode
Via remote control
■ See }8.3.6Remote Control
The status display shows the current operating mode or operating state of the appliance.
The current operating state is indicated by colour and text display:
Appliance is in programme mode
Programme stopped
Appliance is in manual mode
The example on the right shows the appliance in manual mode, as indicated by the
coloured hand symbol.
When the appliance is in timer mode, Timer active is displayed.
When the appliance is in remote control mode, the symbol appears in the temperature
display.
See also
2 Manual Mode [}28]
2 Digital Backwards Counter [}29]
2 Programme Mode [}30]
2 Remote Control [}45]
6.5.1 Manual Mode
In this operating mode, the appliance runs continuously with the values set on the
ControlCOCKPIT.
As described in chapter }6.4.2Basic Operation, you can set the following parameters after
pressing the corresponding activation key (in any sequence):
Temperature
Heating operation is indicated by the symbol.
You can display the temperature in °C or °F.
The setting range depends on the appliance (see }3.7Nameplate and
}3.8Technical Data).