Memotec NetPerformer SDM-9220 User Manual

NetPerformer Hardware Installation Guide
B-12 Memotec Inc.
requirement adopted by ACTA of the United States.
On the product nameplate of this equipment (located on the underside of the product
chassis) is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX.
If requested, this number must be provided to the telephone company.
Connection to the Telephone Line
• This equipment uses jacks for connection to the telephone line. You must, upon,
request, provide the following “USOC Jack type” to your local telephone
company:
- For equipment equipped with the interface card 100-1107-003/004, the
USOC
jack type: RJ11C
.
- For equipment equipped with the interface card 100-1111-001/002, the
USOC
jack type: RJ48C
.
• This equipment cannot be used on the public coin phone service provided by the
telephone company. Connection to party line service is subject to state tariffs.
• Your telephone company may discontinue your service if your equipment causes
harm to the telephone network. They will notify you in advance of disconnection,
if possible. During notification, you will be informed of your right to file a complaint
to the FCC.
• Occasionally, your telephone company may make changes in its facilities,
equipment, operation, or procedures that could affect the operation of your
equipment. If so, you will be given advance notice of the change to give you an
opportunity to maintain uninterrupted service.
• THE REGISTRATION NUMBER OF THE SYSTEM MUST BE PROVIDED SO
THAT THE TELEPHONE COMPANY CAN ASCERTAIN INTENDED MODES OF
OPERATION AND VERIFICATION OF REGISTRATION PORTS.
• If a need arises in the future, the telephone company will call the user and
request the following information for any equipment being connected to the
Public Switched Telephone Network:
For equipment equipped with interface cards 100-1107-003/004 or
-503/504 (Quad/Dual FXO):
- Manufacturer: Memotec Inc.
- Model Number: Refer to the nameplate on the bottom of the unit
- FCC Registration #: Refer to the nameplate (bottom of the unit)
- Ringer Equivalence Number (REN): 0.1B
- Facility Interface Code (FIC): 04DU9-1SN
- Service Order Code (SOC): 6.0F
- Telephone plug: RJ11C
For equipment equipped with interface cards 100-1111-001/002 or –501/502
(Dual/Single T1):
- Manufacturer: Memotec Inc.

Memotec NetPerformer SDM-9220 Specifications

General

Brand	Memotec
Model	NetPerformer SDM-9220
Category	Gateway
Language	English