Mercury 4000 MPC GEN II - Bezel Installation and Clearances

4000 MPC GEN II PISTOL GRIP REMOTE CONTROL INSTALLATION INSTRUCTIONS
90-8M0103111 FEBRUARY 2015 Page 5 / 22
IMPORTANT: Ensure the remote control has a minimum of 45.7 cm (18 in.) straight routing clearance for the control cables
and does not contact other components. Refer to the shaded area.
a - Maximum mounting panel thickness
b - Do not use anchors, clamps, cable ties, or secure any harnesses or other items within 45.7 cm (18 in.) of the control
cables exiting the remote control module
c - Hand clearance
GEN II Series Panel Mount Remote Control Bezel Installation
NOTE: This remote control should be installed on the starboard side only.
41.27 mm
(1.625 in.)
136.52 mm
(5.375 in.)
76.5 mm
(3.00 in.)
25.4 mm
(1.00 in.)
217.50 mm
(8.56 in.)
40.6 mm
(1.60 in.)
142.2 mm
(5.60 in.)
b
a
c
c
25027
(8.62 in.)
R 218.9 mm
(2.00 in.)
50.8 mm
(18.00 in.)
457. mm
(5.81 in.)
147.5 mm
(7.78 in.)
197.6 mm
120.6 mm
(4.75 in.)
353.1 mm
(13.9 in.)
303.3 mm
(11.94 in.)