4000 MPC GEN II PISTOL GRIP REMOTE CONTROL INSTALLATION INSTRUCTIONS
90-8M0103111 FEBRUARY 2015 Page 11 / 22
Pistol Grip Remote Control with Fingertip Lock Release Installation
NOTE: The control handle friction is preset at the factory. To increase or decrease the control handle friction, the adjustment
must be made prior to the installation of the remote control module onto the bezel. When adjusting the control handle friction,
the control cables must be installed, and the control handle temporarily installed onto the control module to get a true feel for
the amount of control handle friction.
1. Route the trim switch leads from the control handle assembly through the bezel cover and bezel opening.
2. Allow sufficient slack in the trim switch leads to permit free movement through the full range of the control handle motion.
Do not restrain the trim switch leads with cable ties.
a - Bezel opening
b - Trim switch
c - Trim leads
d - Bezel cover
IMPORTANT: Ensure the trim switch leads are not pinched when mounting the remote control module to the bezel. The
trim switch leads must be free to move with the full range of the control handle motion.
3. Install the remote control module to the bezel. Secure the remote control module with three screws. Tighten the screws to
the specified torque.
a - Control module mounting screw (3)
b - Control module
Description Nm lb‑in. lb‑ft
Control module mounting screw (3) 5.6 50 –
To Next Page
Loading...