Mercury 60 4-Stroke User Manual

OUTBOARD INSTALLATION
106
NOTE: The inside holes on the transom reinforcement plate are
for the lower transom bolts and the outside holes are for the upper
transom bolts.
a
b
20860
a - Large transom washer
b - Transom reinforcement plate
Description Part Number
Large transom washer 67‑896392
Transom reinforcement plate 67‑896305
Fastening the Outboard to the Transom
1. Install the outboard so that the anti‑ventilation plate is in‑line
or within 25 mm (1 in.) below the bottom of the boat.
a
b
8045
a - Anti‑ventilation plate
b - 25 mm (1 in.)
2. Apply marine sealer to the shanks of bolts, not the threads.
3. Fasten the outboard with the provided mounting hardware.
Tighten the locknuts to the specified torque.

Mercury 60 4-Stroke Specifications

General

Engine Type	4-Stroke
Horsepower	60 hp
Displacement	995 cc
Fuel System	Electronic Fuel Injection (EFI)
Alternator Output	18 amp / 226 watt
Starting	Electric
Cylinders	4 (inline)
Shaft Length	20" or 25"
Full Throttle RPM Range	5000-6000
Warranty	3-Year Limited Warranty