Mercury 60 4-Stroke - Page 127

OUTBOARD INSTALLATION
119
2. Fit the throttle cable through the rubber grommet.
a
b
28491
a - Rubber grommet b - Throttle cable
3. Attach the throttle cable to the throttle lever with a cotter pin
retainer.
4. Adjust cable barrel until the barrel slips onto the mounting
stud.
5. Fasten the throttle cable to the mounting stud with a flat
washer and locknut. Tighten the locknut to the specified
torque.
28494
b
a
c
d
e
a - Throttle cable
b - Cotter pin retainer
c - Flat washer
d - Locknut
e - Cable barrel
Description Nm lb. in. lb. ft.
Throttle cable locknut 6 53