Mercury HP700 SCi - Page 77

MAINTENANCE
69
CHECKING TRANSOM INPUT SHAFT BEARING HOUSING
(DRIVE-LINE MODELS ONLY)
1. Remove the level indication (middle) pipe plug from the input
shaft housing. Gear lube level should be to the bottom of the
hole. If not, remove the pipe plug from the top of the input shaft
housing.
2. Fill the input shaft housing through the top pipe plug hole with
High Performance Gear Lube until gear lube flows from the
middle pipe plug hole (do not overfill).
3. Install the pipe plugs into the input shaft housing and tighten
securely.
a
b
c
21730
a - Fill hole
b - Check level here
c - Drain
Tube Ref No. Description Where Used Part No.
87
High Performance
Gear Lubricant
Transom input shaft
bearing housing
92-858064K01